Kia Sedona: Description and Operation

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Auto Lighting Control System / Description and Operation

Description

It''s a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment''s illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.

1.	Do not place other devices on top of this device.

2.	Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.

3.	Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may vary depending on the climate, season, and surrounding environment.

4.	Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.

5.	Error may occur if light block coating that may change interior illumination is applied.

Schematic Diagrams

Circuit Diagram ...

Auto Light Sensor Repair procedures

Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor''s input (illuminat ...

Other Information:

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it ...

72,000 km (45,000 miles) or 36 months
❑ Rotate tire ❑ Inspect battery condition ❑ Inspect air cleaner filter ❑ Inspect vacuum hose ❑ Inspect air conditioning refrigerant ❑ Inspect brake hoses ...

Kia Sedona: Description and Operation

Schematic Diagrams

Auto Light Sensor Repair procedures

Other Information:

Categories