Kia Optima Manuals

Kia Sedona: Audio Remote Control Repair procedures - Audio - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Audio Remote Control Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Audio / Audio Remote Control Repair procedures

Diagnosis With GDS
1.
The body electrical systems can quickly be diagnosed for failed parts using the available vehicle diagnostic systems (GDS).
The diagnostic systems (GDS) provide the following information.
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point adjustment
2.
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester.
3.
Select the ''Multi Function Switch (MFSW)'' to check the Multi Function Switch (MFSW).
4.
Select the ''Current data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the Multi Function Switch (MFSW) can be checked.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the screw and loosen the steering remote control (A).
[LH]

[RH]

4.
Remove the steering remote control connectors (A).
[LH]

[RH]

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Install the driver airbag module.
3.
Connect the negative (-) battery terminal.
Audio Remote Control Schematic Diagrams
Circuit Diagram ...

Multimedia Jack Components and Components Location
Component ...

Other Information:

Warning lights
✽ NOTICE - Warning lights Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention. ...

Parking Assist Sensor Repair procedures
Removal Front/Rear PAS Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Co ...

Categories

Copyright © www.kisedona.com 2016-2026