Kia Sedona: Rear Spoiler Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Body Side Moulding / Rear Spoiler Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the tail gate upper trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).

Remove the rear spoiler plug hole cap (A) and then loosen the nuts (B).

Tightening torque :

5.9 ~ 6.4N.m (0.6 ~ 0.65kgf.m, 4.3 ~ 4.7lb-ft)

4.	Remove the rear spoiler (A).

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

Roof Side Moulding Repair procedures

Replacement [General Type] Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with pro ...

Front Wheel Guard Repair procedures

Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Other Information:

In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal. WARN ...

Schematic Diagrams
Schematic Diagram Canister Canister is filled with charcoal and absorbs evaporated vapor in fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by the ECM/PCM when ...

Kia Sedona: Rear Spoiler Repair procedures

Roof Side Moulding Repair procedures

Front Wheel Guard Repair procedures

Other Information:

Categories