Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Disconnect the rear door cable (A). |
3. |
Disconnect the rear door remote controller connector (B). |
4. |
Loosen the bolts and remove the rear door remote controller (A). |
5. |
Loosen the screw and disconnect the rear door outside handle cable (A). |
6. |
Loosen the nuts (B) and remove the rear door front channel (A). |
7. |
Separate the fixed pin (B) and remove the rear door outside handle cover (A). |
8. |
Separate plug hole (A) and then remove the bolt. |
9. |
Press the fixed pin and then remove the rear door outside handle base (A). |
10. |
Install in the reverse order of removal.
|
Drive Belt Components and Components Location
Components
1. Drive belt (With HPS)2. Drive belt (With MDPS)
...
Rear Power Mosfet Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower motor.
3.
Operate the control switch to raise the voltage up to high ...