Kia Optima Manuals

Kia Sedona: Hood Latch Release Handle Repair procedures - Hood - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Hood Latch Release Handle Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
   
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Install in the reverse order of removal.
   
•
Make sure that the hood latch cable is connected properly.
•
Make sure that the hood locks/unlocks and opens/closes properly.
Hood Latch Release Handle Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch Components and Components Location
Component Location 1. Hood lower latch assembly ...

Other Information:

Sunroof
Front Rear If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console. The sunroof can only be opened, close ...

Rear Evaporator Core Repair procedures
Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Remove the rear heater & A/C lower case after loosening the screws. 3. Remove the ...

Categories

Copyright © www.kisedona.com 2016-2026