Kia Sedona: Parking Brake Assembly Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Brake System / Parking Brake System / Parking Brake Assembly Repair procedures

Removal

Parking Brake Shoe

1.	Raise the vehicle, and make sure it is securely supported.

2.	Remove the rear tire and wheel.

3.	Remove the rear brake caliper and Rear disc brake. (Refer to "Rear disc brake removal")

4.	Remove the parking brake cable (A).

5.	Remove the hub assembly. (Refer to Drive shaft and axle - "Rear hub - carrier")

6.	Remove the adjuster assembly (B) and the lower return spring (A).

7.	Remove the upper return spring (A) operating lever assembly (B).

8.	Remove the shoe hold down pin (A) and the spring (B) by pressing and rotating the spring.

9.	Remove the brake shoes (C).

Installation

Parking Brake Shoe

1.	Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.

2.	Install the operating lever assembly (B) and the upper return spring (A).

3.	Install the adjuster assembly (B) and the lower return spring (A).

4.	Install the hub assembly. (Refer to Drive shaft and axle - "Rear hub - carrier")

5.	Install the parking brake cable (A).

Install the rear brake disc, then adjust the rear brake shoe clearance.

(1)	Remove the plug from the disc.

(2)	Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.

7.	Install the brake caliper assembly. (Refer to Brake system - "Rear disc brake")

8.	Install the tire and wheel, after installing the plug on the disc.

If the parking brake shoe or the brake disc is replaced with a new one, perform the brake shoe bed-in procedure.

(1)	While operating the parking brake for 69N (7kgf, 15lbf) effort, drive the vehicle 500 meters (0.31 miles) at the speed of 60kph (37 mph).

(2)	Repeat the above procedure more than two times.

(3)

Must be held on 30% uphill.

After adjusting parking brake, notice following matter;

1)	Pedal type - Must be free from troubles when the parking pedal is operated at 980N (100kgf, 220 lbf)

2)	Check that all parts move smoothly.

3)	The parking brake indicator lamp must be on after the parking pedal is worked and must be off after the pedal is released.

Components and Components Location

Components (1) 1. Parking brake pedal assembly2. Front parking brake cable3. Equalizer assembly4. Rear parking brake cable Components (2) 1. Brake shoe2. Operating lever3. Upper spring4. Lo ...

Parking Brake Pedal Assembly Repair procedures

Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") 3. Remove the junction b ...

Other Information:

Sunvisor Repair procedures
Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, an ...

Front Door Side Weatherstrip Repair procedures
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, and then remove the front doo ...

Kia Sedona: Parking Brake Assembly Repair procedures

Components and Components Location

Parking Brake Pedal Assembly Repair procedures

Other Information:

Categories