Kia Sedona: Front Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Kia Sedona YP Service ManualKia Sedona: Front Wheel Speed Sensor Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor Repair procedures

Removal
1.
Remove the front wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the front wheel guard .
4.
Remove the front wheel speed sensor cable mounting bolt (A).

5.
Disconnect the front wheel speed sensor connector (B) and then remove the front wheel speed sensor.

6.
Install in the reverse order of removal.
Front Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Other Information:

Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Warranty & Maintenance booklet in your vehicle. Your ...

Troubleshooting
Engine Overheat Troubleshooting Inspection RemedyVisual inspectionInspect for shortage of coolant in reservoir tank .Reinspect after replenishing coolant.Inspect for coolant pollution after remo ...

Categories


Copyright В© www.kisedona.com 2016-2025