Kia Optima Manuals

Kia Sedona: Brake Switch Repair procedures - Brake System - Brake System - Kia Sedona YP Service ManualKia Sedona: Brake Switch Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Brake System / Brake System / Brake Switch Repair procedures

Removal
1.
Disconnect the brake switch connector (A).

2.
Pull the locking plate (A) as indicated by the arrow.

3.
Turn brake switch 45° counterclockwise and remove it.

Inspection
1.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger is pushed.

Installation
1.
Fix the brake pedal arm and insert fully the brake switch so that the contact part is invisible.

2.
After inserting, turn the brake switch 45° clockwise, and then assemble locking plate by pushing.

3.
Confirm the gap between brake switch and bracket.
Brake clearance (A):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

4.
Connect the brake switch connector (A).

Adjustment
Brake switch clearance adjustment
If the gap between brake switch and bracket is not 1.0 - 2.0 mm (0.04 - 0.08 in.), follow the procedure below:
1.
Disconnect the brake switch connector (B).

2.
Pull the locking plate (A) as indicated by the arrow.

3.
Turn brake switch 45° counterclockwise and remove it.

4.
Fix the brake pedal arm and insert fully the brake switch so that the contact part is invisible.

5.
After inserting, turn the brake switch 45° clockwise, and then assemble locking plate by pushing.

6.
Confirm the gap between brake switch and bracket.
Brake clearance (A):
1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

7.
Connect the brake switch connector (A).

Brake Pedal Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel and reinforcing panel. (Refer to the Body group- crash pad). 3. Remov ...

Front Disc Brake Components and Components Location
Components 1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

Other Information:

Variable Intake Solenoid (VIS) Valve Description and Operation
Description Variable Intake manifold Solenoid (VIS) valves are installed on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2). VIS valves 1 and 2 control vacuum modulators that ...

Operating condition
This system will activate when the indicator on the rear parking assist OFF button is not illuminated. If you desire to deactivate the rear parking assist system, press the rear parking assis ...

Categories

Copyright © www.kisedona.com 2016-2026