Kia Sedona: TPMS Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Repair procedures

Removal

1.	Remove the tire. (Refer to Tires/Wheels - "Tire")

Remove the screw with torx driver (A).

•	When installing the bead brake, make sure that it does not come in contact with the TPMS sensor.

•	Be careful not to damage the TPMS sensor when installing the bead brake near the TPMS sensor.

3.	Remove the sensor body (A) from the valve (B) in the direction of the arrow.

Use the valve mounting tool to pull out the valve until it is entirely out of the lower hole.

Cut the rubber at the bottom of valve with a knife.

Apply lubricant to the surface of the valve, and then mount it through the valve hole of the wheel.

Regular soapy water is recommended as the lubricant.

•	The TPMS sensor valve bottom is not properly sealed if it is not fully mounted on the wheel, as shown in the following figure:

•	Make sure that the valve body is pulled entirely through the hole.

6.	Apply soapy water or lubricant to the upper/lower bead section of the tire.

7.	In order to mount the lower beads, place the TPMS sensor at 5 o''clock, starting from the head of the tire replacement equipment.

Rotate the rim clockwise and press tire towards 3 o''clock to mount the lower beads.

•	Mount the tire on the wheel. Make sure that the beads touch the edge of the rim behind the sensor (towards 6 o''clock).

9.	In order to mount the upper beads, press the tire towards 3 o''clock and turn the rim clockwise.

10.	Inject air into the tire until the beads are in the correct position.

11.	Adjust the tire pressure according to the recommended tire pressure for the vehicle.

12.	If the TPMS sensor malfunctions, the TPMS sensor learning must be performed. Replace any faulty sensors and perform TPMS sensor learning.

Diagnosis procedure using GDS

To give guidance for diagnosing using diagnosis device, refer to the following:

1.	Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnosis device, and then turn on the self-diagnosis device after key is ON.

2.	Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.

[System Identification (Wireless)]

[Sensor ID Writing (Wireless)]

[VIN input initialization]

[Vehicle name input initialization]

[Sensor Status initialization]

[Register Sensor initialization]

•	Write ID/Read ID should be the same.

•	After successful registration of the sensor, execute "Sensor Wireless Information" menu to confirm that it is working properly.

TPMS Sensor Description and Operation

Description 1. Function • By detecting the pressure, temperature, acceleration, and battery condition, transmit information to ECU by a wireless RF. • 2. Structure and f ...

TPMS Receiver Description and Operation

Description 1. Mode (1) Virgin State • The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. • In this state, there ...

Other Information:

Fuel Tank Pressure Sensor (FTPS) Specifications
Specification ItemSpecificationSupply Voltage (V)5Operation Voltage (V)4.75 ~ 5.25 Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5 ...

Rear Bumper beam Assembly Components and Components Location
Component Location 1. Rear Bumper Beam Assembly ...

Kia Sedona: TPMS Sensor Repair procedures

TPMS Sensor Description and Operation

TPMS Receiver Description and Operation

Other Information:

Categories