Kia Sedona: Wheel Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Tires/Wheels / Wheel Repair procedures

Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

Measure the wheel Run-out by using a dial indicator as in the illustration below.

Run-out	Aluminum	Aluminum
Radial mm(in.)	0.3(0.0118)	0.7(0.028)
Lateral mm(in.)	0.3(0.0118)	1.1(0.043)

3.	If measured value exceeds the standard value, replace the wheel.

Tire Repair procedures

Tire Wear • Using tires and wheels of other than the recommended sizes can cause unusual handling characteristics and poor vehicle control, resulting in a ...

Tire Pressure Monitoring System

...

Other Information:

Outside lamp
1. Open the tailgate. 2. Loosen the lamp assembly retaining screws with a philips head screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Remove the so ...

ECO mode (Active ECO)
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle system operating parameters. Fuel efficiency depends on the driver's driving habit and road condition. ...

Kia Sedona: Wheel Repair procedures

Tire Repair procedures

Tire Pressure Monitoring System

Other Information:

Categories