Kia Sedona: Dynamic Damper Components and Components Location - Driveshaft Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: Dynamic Damper Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and Components Location

Components

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Retainer ring
12. TJ housing
13. Housing circlip

Front Driveshaft Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to dam ...

Dynamic Damper Repair procedures
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Remo ...

Other Information:

Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle's driver and/or the front passenger with additional protection than th ...

Operating condition
This system activates when the parking assist button is pressed with the Engine Start/Stop Button ON. The parking assist button turns on automatically and activates the parking assist sys ...

Categories


Copyright © www.kisedona.com 2016-2025