Kia Sedona: Fuel Filler Cap Description and Operation
Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation
| Description |
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which would seal the fuel
filler. After the gasket on the fuel filler cap and the filler neck
flange contact each other, the ratchet produces a loud clicking noise
indicating the seal has been set.
| 1. Cover 2. Torsion spring 3. Retainer 4. Gasket seal | 5. Spring 6. Plate seal 7. Vacuum valve 8. Spring |
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the fuel tank.
(Refer to Engine Control / Fuel System - "Fuel Tank")
3.
Disconnect the ...
Fuel Tank Air Filter Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect th ...
Other Information:
Tire pressure
Always observe the following:
Check tire pressure when the tires are cold. (After vehicle has been parked
for at least three hours or hasn't been driven more than 1.6 km (one mile) since
...
Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS to the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Pressure [kPa (kgf/cmВІ, psi)]Output Voltage (V) [Ref=5V]20.0 (0 ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2025 Owners Manual
- Kia Sedona YP 2014-2025 Service Manual
Copyright В© www.kisedona.com 2016-2025