Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (10) and signal terminal (7).
|
Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Check high beam assist system
This warning message illuminates if there is a malfunction (burned-out bulb or
circuit malfunction) with the headlamp. In this case, have your vehicle inspected
by an authorized Kia dealer. ...
Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil
be used during cold weather. See section 8 for recommendations. If you aren't sure
what weight oil you s ...