Kia Optima Manuals

Kia Sedona: Seat Belt Pretensioner (BPT) Repair procedures - Seat Belt Pretensioner - Restraint - Kia Sedona YP Service ManualKia Sedona: Seat Belt Pretensioner (BPT) Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work.
2.
Left side - Remove the seat belt lower anchor cover (A). After loosening the mounting bolt, remove the seat belt lower anchor (B).

Right side - To remove the locking mechanism (A), using a flatheaded (-) screwdriver (B), turn it counter clockwise from the emergency fastening device (EFD) system (C).

3.
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Remove the center pillar trim
(Refer to Body - "Center pillar trim")
5.
Remove the upper anchor bolt.
6.
Loosen the seat belt pretensioner mounting bolts (A,B) and remove the seat belt pretensioner.

7.
Disconnect the seat belt pretensioner connector (C).
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Connect the seat belt pretensioner (BPT) connector (C).

4.
Install the seat belt pretensioner with bolts (A, B).
Tightening torque
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
5.
Install the upper anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the center pillar trim
(Refer to Body - "Center pillar trim")
7.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
8.
Left side - Install the lower anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Right side - Insert the seat belt to the Emergency fastening device (A).

   
Make sure that the lock pin is connected properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Seat Belt Pretensioner (BPT) Components and Components Location
Components ...

Emergency Fastening Device (EFD) Description and Operation
Description Emergency Fastening Device (EFD) is deployed concurrently with the Belt Pretensioner to strongly pull down the seat belt during a deployment condition after a collision. It is locat ...

Other Information:

Drive Plate Components and Components Location
Components 1. Drive plate2. Adapter plate ...

Relay Box (Passenger Compartment) Description and Operation
Description Auto Cut System Of Dark Current AbbreviationExplanationACUAirbag Control UnitADMAssist Door ModuleB_CANBody Controller Area NetworkBCMBody Control ModuleBSDBlind Spot DetectionC_CANC ...

Categories

Copyright © www.kisedona.com 2016-2026