Kia Sedona: Rear Stabilizer Bar Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Repair procedures

Removal

Remove the rear wheel and tire (A) from rear hub .

Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Remove the rear stabilizer bar (A).

(1)	Loosen the nut (D).

(2)	Loosen the bolt (B) and nut (C).

(3)	Remove the stabilizer bar (A).

3.	Install in the reverse order of removal.

Inspection

1.	Check the rear stabilizer bar for deformation.

2.	Check the rear stabilizer link ball joint for damage.

Rear Assist Arm Repair procedures

Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage ...

Rear Sub Frame Repair procedures

Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage ...

Other Information:

Illuminated ignition switch
Whenever a front door is opened, the ignition switch will illuminate for your convenience, provided the ignition switch is not in the ON position. The light will go off immediately when the igni ...

Power Sliding Door (PSD) Control Module Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [LH]. (Refer to Body - "Luggage Side Trim") 3. Disconnect the power sliding door control module co ...

Kia Sedona: Rear Stabilizer Bar Repair procedures

Rear Assist Arm Repair procedures

Rear Sub Frame Repair procedures

Other Information:

Categories