Kia Sedona: Rear Door Power Window Regulator Repair procedures - Rear Door - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Door Power Window Regulator Repair procedures

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Power Window Regulator Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Loosen the mounting nut and remove the rear door power window regulator connector (A).

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

3.
Remove the rear door power window regulator assembly (A) from the rear door panel.

4.
Install the reverse order of removal.
Rear Door Power Window Regulator Components and Components Location
Component Location 1. Rear door module ...

Rear Door Outside Handle Components and Components Location
Component Location 1. Rear door outside handle ...

Other Information:

Injector Drive Box (IDB) Repair procedures
Removal 1. Turn the ignition switch off and disconnect the battery negative (-) Terminal. 2. Remove the mounting nuts (A) and disconnect the connector (B), and then remove the injector drive b ...

Emergency Fastening Device (EFD) Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work. 2. To remove the locking mechanism (A), using a flatheaded (-) screwdriver (B), ...

Categories


Copyright В© www.kisedona.com 2016-2025