Kia Sedona: Rear combination lamp Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Rear combination lamp Repair procedures
| Removal |
Rear Combination Lamp (Outside)
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or remover, remove the rear combination lamp cover (A).
|
| 3. |
Remove the rear combination lamp (A) after loosening the mounting screws.
|
| 4. |
Disconnect the rear combination lamp connector (A).
|
Bulb Replacement
| 1. |
Remove the rear combination lamp. |
| 2. |
Remove the turn signal lamp bulb (B) by turning the socket (A) counterclockwise.
|
Rear Combination Lamp (Inside)
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear combination lamp cover (A).
|
| 3. |
Disconnect the rear combination lamp connector (A).
|
| 4. |
Remove the rear combination lamp (A) after loosening the mounting nuts.
|
Bulb Replacement
| 1. |
Remove the rear combination lamp cover. |
| 2. |
Remove the stop/tail lamp (B) by turning the socket (A) counterclockwise.
|
| Installation |
Rear Combination Lamp (Outside)
| 1. |
Connect the rear combination lamp connector. |
| 2. |
Install the rear combination lamp. |
| 3. |
Install the rear combination lamp cover. |
| 4. |
Connect the negative (-) battery terminal. |
Rear Combination Lamp (Inside)
| 1. |
Install the rear combination lamp. |
| 2. |
Connect the rear combination lamp connector. |
| 3. |
Install the rear combination lamp cover. |
| 4. |
Connect the negative (-) battery terminal. |
High Mounted stop lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear spoiler.
(Refer to Body - "Rear Spoiler")
3.
Remove the high mounted stop lamp assembly (A) after loosening nut ...
Troubleshooting
Troubleshooting
SymptomPossible causeRemedyOnly one lamp lights on(All exterior lamps)Bulb burned outReplace bulbSocket, wiring or ground faultyRepair if necessaryHead lamps do not light onBulb b ...
Other Information:
Front Hub / Knuckle / Tone Wheel Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damag ...
Sunroof Motor Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the sunroof motor (A) connector.
[Fron ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026