Kia Sedona: Parking Brake Cable Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Brake System / Parking Brake System / Parking Brake Cable Repair procedures
| Removal |
| Parking brake pedal Type |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel") |
| 3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
| 4. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
(Refer to Body - "Floor console") |
| 6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 7. |
Raise the vehicle, and make sure that it is securely supported. |
| 8. |
Remove the rear wheel & tire. |
| 9. |
Remove the parking brake cable (A).
|
| 10. |
Loosen the parking brake cable bracket bolts and remove the rear parking brake cable. |
| 11. |
Install in the reverse order of removal. |
Parking Brake Pedal Assembly Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the junction b ...
Other Information:
Barometric Pressure Sensor (BPS) Schematic Diagrams
Circuit Diagram
...
Hood Insulator Pad Repair procedures
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.
2.
Install ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026