2nd row outboard seat
3rd row seat
Child restraint hook holders are located on the back of the rear cushions.
1. Route the child restraint seat strap over the seatback. For vehicles with adjustable headrests, route the tether strap under the headrest and between the headrest posts, otherwise route the tether strap over the top of the seatback. In case of interference between the child restraint seat and the headrest remove the particular head restraint for better fitment of the child restraint seat.
2. Connect the tether strap hook to the appropriate child restraint hook holder and tighten to secure the child restraint seat.
WARNING - Tether strap
Never mount more than one child restraint to a single tether or to a single lower anchorage point. The increased load caused by multiple seats may cause the tethers or anchorage points to break.
Check that the child restraint system is secure by pushing and pulling it in different directions. Incorrectly fitted child restraints may swing, twist, tip or separate causing death or serious injury.
Shift Lever Repair procedures
Removal
1.
Move the shift lever to "N" range.
2.
Disconnect the battery negative (-) cable.
3.
Remove the knob (A) and boots (B) by pulling them in the
direction of the arrow after separ ...
Turn signals when towing a trailer
When you tow a trailer, your vehicle has to have a different turn signal flasher
and extra wiring. The green arrows on your instrument panel will flash whenever
you signal a turn or lane change. P ...