Kia Sedona: Parking Assist Sensor Repair procedures
Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Front / Rear Parking Assist System / Parking Assist Sensor Repair procedures
| Removal |
Front/Rear PAS Sensor
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front/rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover") |
| 3. |
Disconnect the connector from the ultrasonic sensor.
[Front, Rear Center]
[Rear Side Left]
[Rear Side Right]
|
| 4. |
Pull out the ultrasonic sensor (A) after opening the sensor holder.
[Front, Rear Center]
[Rear Side Left]
[Rear Side Right]
|
| Installation |
Front/Rear PAS Sensor
| 1. |
Install the PAS sensor and connector. |
| 2. |
Install the front/rear bumper cover. |
| 3. |
Connect the negative (-) battery terminal. |
Parking Assist Sensor Schematic Diagrams
Circuit Diagram
...
Fuses And Relays
...
Other Information:
Anti-lock Brake System (ABS) Warning Light
This warning light illuminates :
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When there i ...
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce
the risk of unauthorized vehicle use.
Your immobilizer system is comprised of a small transponder in the ignition key ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2026 Owners Manual
- Kia Sedona YP 2014-2026 Service Manual
Copyright © www.kisedona.com 2016-2026