Kia Sedona: Rear Bumper Cover Repair procedures| Replacement |
|
Take care not to bend or scratch the trim and panels. |
| 1. |
Remove the rear combination lamp cover (A) using a screwdriver or remover.
|
| 2. |
After loosening the mounting screws, remove the rear combination lamp (A).
|
| 3. |
Push the lock pin, then disconnet the rear combination lamp connector (A).
|
| 4. |
Loosen the clips on rear bumper upper.
|
| 5. |
Remove the rear mud guard (A) after loosening the screws.
|
| 6. |
Remove the rear bumper side under cover (A) after loosening the mounting clips.
[LH]
[RH]
|
| 7. |
Disconnect the rear bumper side.
|
| 8. |
Push the lock pin, then disconnect the rear bumper main connector (A).
|
| 9. |
Remove the rear bumper cover (A).
|
| 10. |
Install in the reverse order of removal.
|
Rear Bumper Cover Components and Components Location
Rear Bumper beam Assembly Components and Components LocationCarry emergency equipment
Depending on the severity of the weather, you should carry appropriate emergency
equipment. Some of the items you may want to carry include tow straps or chains,
flashlight, emergency flares, sand ...
Forward and backward
To move the seat forward or backward :
1. Pull the seat slide adjustment lever up and hold it.
2. Slide the seat to the position you desire.
3. Release the lever and make sure the seat is locked ...