Kia Sedona: Keyless Entry And Burglar Alarm

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm

IMS Control Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Install the driver''s door trim. (Refer to Body - "Front Door Trim") 3. Remove the IMS switch (A) after loosening the screws. ...

Specifications

Specification ItemSpecificationRated voltage3VOperating temperature-30°C ~ +60°C (-22°F ~ +140°F)RF ModulationFSKLF ModulationASKRF frequency433.92 MHzButton number4 or 6FunctionDoor lockDoor ...

Other Information:

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when : 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with for ...

SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 3. Remove the floor console. (Re ...