LOCK
The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position.
ACC (Accessory)
The steering wheel is unlocked and electrical accessories are operative.
If difficulty is experienced turning the ignition switch to the ACC position, turn the key while turning the steering wheel right and left to release the tension.
ON
The warning lights can be checked before the engine is started. This is the normal running position after the engine is started.
Do not leave the ignition switch ON if the engine is not running to prevent battery discharge.
START
Turn the ignition switch to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position. The brake warning light can be checked in this position.
The anti-theft steering column lock (if equipped) is not a substitute for the parking brake. Before leaving the driver
Rear Seat Belt Retractor Repair procedures
Replacement
[Second row seat belt retractor]
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interi ...
Heater & A/C Control Unit (Manual) Components and Components Location
Component
Connector Pin Function
Connector Pin NoFunctionConnector Pin NoFunctionA1COMMONB18-2GND19ILL- (RHEO)3HIGH20GND4LOW21IGN 25MIDDLE LOW22ECV+6MIDDLE HIGH23ECV-(GND)B1BATT24-2I ...