Kia Sedona: Ignition Switch Assembly

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body Electrical System / Ignition Switch Assembly

Repair procedures

Removal [Horn (Low pitch)] 1. Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the mounting clip (A). 3. Remove the low pitch ...

Repair procedures

Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3. If continu ...

Other Information:

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Schematic Diagrams
Circuit Diagram Connector Pin Information No.Motor ConnectorSunroof Wiring Connector1Battery 1GND 12Open alarmRear lock switch3GND 1IGN4Rear lock switchSignal C5-Signal A6Signal CBattery 17Signa ...