Kia Sedona: High mounted stop lamp replacement - Light bulbs - Maintenance - Kia Sedona YP Owners ManualKia Sedona: High mounted stop lamp replacement

Third generation YP (2014-2025) / Kia Sedona YP Owners Manual / Maintenance / Light bulbs / High mounted stop lamp replacement

1. Open the tailgate.

2. Gently remove the center cover of the rear tailgate trim.

3. Disconnect the electrical connector.

4. Loosen the retaining nuts and remove the spoiler.

5. Remove the high mounted stop light assembly after loosening the screws.

6. Reinstall a new light assembly in the reverse order of removal.

Inside lamp
Type A Type B 1. Open the tailgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the s ...

License plate light bulb replacement
1. Loosen the lens retaining screws with a phillips head screwdriver. 2. Remove the lens. 3. Remove the bulb by pulling it straight out. 4. Install a new bulb. 5. Reinstall the lens securely wit ...

Other Information:

On curves
On curves, the SCC may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed. Also, the vehicle speed will rapidly slow down when the vehicle ahead ...

Yaw-rate and G Sensor Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 3. Remove the floor console. (Re ...

Categories


Copyright В© www.kisedona.com 2016-2025