Kia Sedona: Front Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Kia Sedona YP Service ManualKia Sedona: Front Wheel Speed Sensor Repair procedures

Third generation YP (2014-2023) / Kia Sedona YP Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor Repair procedures

Removal
1.
Remove the front wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the front wheel guard .
4.
Remove the front wheel speed sensor cable mounting bolt (A).

5.
Disconnect the front wheel speed sensor connector (B) and then remove the front wheel speed sensor.

6.
Install in the reverse order of removal.
Front Wheel Speed Sensor Components and Components Location
Components 1. Front wheel speed sensor2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Other Information:

Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower switch (A) after loos ...

Blind Spot Detection Switch Schematic Diagrams
Circuit Diagram ...

Categories


Copyright В© www.kisedona.com 2016-2023