Kia Optima Manuals

Kia Sedona: Curtain Airbag (CAB) Module Repair procedures - Airbag Module - Restraint - Kia Sedona YP Service ManualKia Sedona: Curtain Airbag (CAB) Module Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work.
2.
Remove the roof trim.
(Refer to Body - "Roof trim assembly")
3.
Disconnect the curtain airbag harness connector (A).

4.
After loosening the mounting bolts and nuts remove the curtain airbag.

Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts and nuts.
Tightening torque
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nunt : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
   
•
Never twist the airbag module during installation as twisted module may result in abnormal operation. (of the airbag module.)
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to Body - "Roof trim assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Components and Components Location
Components ...

Airbag Module Disposal Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airba ...

Other Information:

To set cruise control speed
Type A Type B 1.Press the CRUISE button on the steering wheel to turn the system on.The CRUISE indicator light in the instrument cluster will illuminate. 2.Accelerate to the desired speed, wh ...

Front Wiper Motor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm. 3 ...

Categories

Copyright © www.kisedona.com 2016-2026