Kia Sedona: Front Driveshaft Components and Components Location - Driveshaft Assembly - Driveshaft and axle - Kia Sedona YP Service ManualKia Sedona: Front Driveshaft Components and Components Location

Third generation YP (2014-2025) / Kia Sedona YP Service Manual / Driveshaft and axle / Driveshaft Assembly / Front Driveshaft Components and Components Location

Components

1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)

[LH]

1. BJ assembly
2. Clip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Circlip
12. TJ housing
13. Circlip

[RH]

1. BJ assembly
2. Clip 
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Circlip
12. TJ housing
13. Circlip

Driveshaft Assembly
...

Front Driveshaft Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to dam ...

Other Information:

Battery replacement
A smart key battery should last for several years, but if the smart key is not working properly, try replacing the battery with a new one. If you are unsure how to use your smart key or replace ...

Evaporator Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistance between terminals “+” and “-” of the evaporator tempera ...

Categories


Copyright © www.kisedona.com 2016-2025