Kia Sedona: Components and Components Location - Emission Control System - Kia Sedona YP Service ManualKia Sedona: Components and Components Location

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Emission Control System / Components and Components Location

Components Location

1. PCV Valve
2. Canister
3. Purge Control Solenoid Valve (PCSV)
4. Fuel Tank Pressure Sensor (FTPS)
5. Canister Close Valve (CCV)
6. Fuel Level Sender (FLS)
7. Fuel Tank Air Filter
8. Catalytic Converter (WCC, Bank 1)
9. Catalytic Converter (WCC, Bank 2)
10. Catalytic Converter (UCC)

1. PCV Valve
2. Canister

3. Purge Control Solenoid Valve (PCSV)
4. Fuel Tank Pressure Sensor (FTPS)

5. Canister Close Valve (CCV)
7. Fuel Tank Air Filter
6. Fuel Level Sender (FLS)

8. Catalytic Converter (WCC, Bank 1)
9. Catalytic Converter (WCC, Bank 2)

10. Catalytic Converter (UCC)


Specifications
Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification ItemSpecificationCoil Resistance (Ω)22.0 ~ 26.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ▷ Type: Piezo-Resi ...

Description and Operation
Description Emissions Control System consists of three major systems. • Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. This system recycles ...

Other Information:

Canister Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - "Fuel Tank") 3. Disconnect the ...

Rear Wheel Speed Sensor Repair procedures
Removal 1. Remove the rear wheel speed sensor connector (A). 2. Remove the rear wheel speed sensor. (Refer to Driveshaft and Axle - "Rear Hub - Carrier") 3. Install in the reverse order o ...

Categories


Copyright © www.kisedona.com 2016-2024