Kia Optima Manuals

Kia Sedona: Climate Control Air Filter Repair procedures - Body - Maintenance - Kia Sedona YP Service ManualKia Sedona: Climate Control Air Filter Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Maintenance / Body / Climate Control Air Filter Repair procedures

Filter inspection
The climate control air filter should be replaced according to the maintenance schedule.
If the vehicle is operated in severely polluted city or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier than schedule.
When replacing the climate control air filter, replace in the following procedure and be careful not to damage other components.
Cleaning
1.
Remove the climate control air filter.
2.
Check that the climate control air filter is not excessively dirty.
   
If the climate control air filter is excessively dirty, replace the climate control air filter.
3.
When cleaning the climate control air filter, blow compressed air as shown in the illustration to clean it.

   
Be careful with the direction of the compressed air on the climate control air filter.
Replacement
1.
Disconnect the stopper (B) from the glove box (A).

2.
Disconnect the air damper (A) from the glove box (B).

3.
Remove the filter cover (A) by pressing the knob.

4.
Replace the air filter (A) with a new one according to the direction of air filter.

   
•
To remove the filter easily, press the right side inward then pull out the filter.
•
In case of driving in an air-polluted area or rugged terrain, check and replace the air filter as frequently as possible.
5.
Install in the reverse order of removal.
Air Conditioner Refrigerant/Compressor Repair procedures
Refrigerant Recovery When removing HFC-134a (R-134a) from the air conditioning system, use only U.L.-listed service equipment certified to meet the requirements of SAE J2210.   ...

Engine Mechanical System
...

Other Information:

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

Inhibitor Switch Repair procedures
Inspection Power Circuit Inspection 1. Disconnect the Inhibitor switch connector. 2. Ignition KEY "ON"" & Engine "OFF".. 3. Measure voltage between supplied power and ground at inhi ...

Categories

Copyright © www.kisedona.com 2016-2026