Kia Sedona: Center Pillar Trim Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Interior Trim / Center Pillar Trim Repair procedures

Replacement

[Center pillar lower trim]

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

Take care not to bend or scratch the trim and panels.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

3.	Remove the front door body side weatherstrip.

4.	Remove the rear door body side weatherstrip.

Disconnect the front seat belt anchor pretensioner and seat belt anchor.

(1)	Keep pushing the lock pin (A) in the direction of the arrow.

(2)	Push the lock pin (B) using a gimlet at the front.

(3)	Remove the front seat belt anchor from front seat belt anchor pretensioner (C).

6.	Remove the center piller lower trim (A) after loosening the screws.

7.	Disconnect the power sliding door switch connector (A).

8.	Install in the reverse order of removal.

[Center pillar upper trim]

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

Take care not to bend or scratch the trim and panels.

1.	Remove the center piller lower trim.

2.	Open the cap, and then remove the center pillar assist handle (A) after loosening the screws.

3.	Remove the front seat belt upper anchor cover (A) using a screwdriver or remover.

4.	Remove the front seat belt upper anchor (A) after loosening the mounting bolt.

5.	Remove the center piller upper trim (A) after loosening the mounting bolt.

Install in the reverse order of removal.

Replace any damaged clips.

Center Pillar Trim Components and Components Location

Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

Rear Transverse Trim Components and Components Location

Component Location 1. Rear transverse trim ...

Other Information:

Variable Intake Solenoid(VIS) Actuator Repair procedures
Removal and Installation VIS 1 [Intake Manifold] 1. Disconnect the battery "-" terminal. 2. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") 3. Disconne ...

In-car Sensor (DATC only) Description and Operation
Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor consists of a thermistor that measures the inside temperature. The signal decided by the r ...

Kia Sedona: Center Pillar Trim Repair procedures

Center Pillar Trim Components and Components Location

Rear Transverse Trim Components and Components Location

Other Information:

Categories