Kia Optima Manuals

Kia Sedona: Battery Sensor Repair procedures - Charging System - Engine Electrical System - Kia Sedona YP Service ManualKia Sedona: Battery Sensor Repair procedures

Third generation YP (2014-2026) / Kia Sedona YP Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures

Removal
1.
Turn the ignition switch OFF.
2.
Disconnect the battery negative (-) terminal (A).
Battery negative (-) terminal tightening nut :
4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft)

3.
Disconnect the battery sensor connector (A).
4.
Remove the battery sensor after loosening the sensor cable flange mounting bolts (B).
Battery sensor cable flange mounting bolt(Chassis ground) :
21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 16.0 ~ 23.9 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.
1)
When replacing the battery, the new battery should be of the same type, capacity and brand with the previous one. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.
2)
When installing the ground cable on the negative post of battery, tighten the clamp to the specified torque. An excessive tightening can damage the PCB internal circuit and the battery terminal.
3)
When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.
Adjustment
Battery Sensor Recalibration Procedure
After reconnecting the battery negative cable, AMS function does not operate until the system is stabilized, for about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work.
1.
Turn the Iginition switch ON and OFF.
2.
Park the vehicle for about 4 hours with the hood and all doors closed.
Battery Sensor Description and Operation
Description Vehicles have many control units that use more electricity. These units control their own system based on information from various sensors. It is important to provide a stable power ...

Cruise Control System
...

Other Information:

Drive Belt Repair procedures
Removal and Installation 1. Remove the engine room under cover and engine room RH side cover. (Refer to Engine And Transaxle Assembly - "Engine Room Under Cover") 2. To release the tension, t ...

Installing the tumble seat (for 8 passenger vehicle)
1. Put the front anchor strikers along the front anchors on the floor. 2. Insert two front anchor strikers into the front anchors. 3. Lift the rear portion of the seat cushion then push down fir ...

Categories

Copyright © www.kisedona.com 2016-2026