Removal |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. |
3. |
Remove the floor console.
(Refer to Body - "Floor console") |
4. |
Pull up the lock, of the SRSCM connector, the disconnect the connector (A). |
5. |
Remove the SRSCM mounting bolts from the SRSCM, then remove the SRSCM. |
SRSCM or other SRS components must be removed or installed
when the ignition switch is turned OFF to avoid accidental airbag
deployment. |
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Install in the reverse order of removal. |
3. |
After installing the SRSCM, confirm proper system operation:
|
G-Sensor Calibration |
1. |
Turn ignition "OFF" and connect GDS. |
2. |
While ignition "ON" & engine "OFF", select vehicle name and ESC system. |
3. |
Perform G-sensor calibration. |
4. |
Perform the "G-Sensor Calibration" procedure with GDS. |
5. |
Complete the "G-Sensor Calibration" procedure. |
Operating condition
This system will activate when the indicator on the rear parking assist
OFF button is not illuminated. If you desire to deactivate the rear parking
assist system, press the rear parking assis ...
One time driving information mode
Type B, C
This display shows trip distance (1), average fuel economy (2) and the vehicle
can be driven with the remaining fuel (3).
This information is displayed for a few seconds when you turn ...