Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the VIS valve connector. |
3. |
Measure resistance between the VIS valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
[Valve 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the variable intake solenoid valve connector (A). |
3. |
Disconnect the vacuum hoses (B) from the valve. |
4. |
Remove the mounting nut (C), and then remove the valve from surge tank. |
[Valve 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the variable intake solenoid valve connector (A). |
3. |
Disconnect the vacuum hoses (B) from the valve. |
4. |
Remove the mounting nut (C), and then remove the valve from surge tank. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Sunroof Inside Air Recirculation
When the heater or air conditioning system is on with the sunroof opened, the
outside (fresh) air position will be automatically selected. At this time, if you
press the recirculated air position ...
Rear Oil Seal Components and Components Location
Components
1. Rear oil seal2. Oil seal case
...