Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between + terminal (9) and - terminal (13). |
5. |
Check that the resistance is within the specification.
|
Removal |
The oil temperature sensor is integrated with the solenoid
valve main connector and can not be disassembled. The oil temperature
sensor should be replaced with the solenoid valve main connector. |
1. |
Move the shift lever to "N" range. |
2. |
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
3. |
Disconnect the input & output speed sensor connector (A). |
4. |
Loosen the solenoid valve harness bolts (B).
|
5. |
Disconnect the solenoid valve connector (A). |
6. |
Remove the clip (A) and then remove the connector by pressing it downward.
|
Installation |
1. |
Install in the reverse order of removal. |
|
Operating condition
This system will activate when the indicator on the rear parking assist
OFF button is not illuminated. If you desire to deactivate the rear parking
assist system, press the rear parking assis ...
Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning
is reduced. Overfilling also has a negative impact on the air conditioning system.
Therefore, if abnormal operation is ...