Kia Sedona: Thermostat Troubleshooting - Cooling System - Engine Mechanical System - Kia Sedona YP Service ManualKia Sedona: Thermostat Troubleshooting

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Mechanical System / Cooling System / Thermostat Troubleshooting

Troubleshooting
Trouble Symptom
Probable Cause
Remedy
Coolant leakage
•
From the thermostat gasket
Check the mounting bolts
•
Check the torque of the mounting bolts
•
Retighten the bolts and check leakage again.
Check the gasket for damage
•
Check gasket or seal for damage
•
Replace gaskets and reuse the thermostat.
Cooled excessively
•
Low heater performance (cool air blowed-out)
•
Thermogauge indicates ''LOW''
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
•
After refilling coolant, recheck.
Check GDS & engine start
•
Check DTCs
•
Check connection of the fan clutch or the fan motor.
※ If the fan clutch is always connected, there will be a noise at idle.
•
Check the engine coolant sensor, wiring and connectors.
•
Replace the components.
Remove the thermostat and inspect
•
Check if there are dust or chips in the thermostat valve.
•
Check adherence of the thermostat.
•
Clean the thermostat valve and reuse the thermostat.
•
Replace the thermostat, if it doesn''t work properly.
Heated excessively
•
Engine overheated
•
Thermogauge indicates ''HI''
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
※Be careful when removing the radiator cap of the overheated vehicle.
•
Check air in cooling system.
•
After refilling coolant, recheck.
•
Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.
Check GDS & engine start
•
Check DTCs
•
Check the fan motor performance as temperature varies.
•
Check if the fan clutch slips.
•
Check the water pump adherence or impeller damaged.
•
Check the engine coolant sensor, wiring and connectors.
•
Check the fan motor, the relay and the connector.
•
Replace the fan clutch, if it doesn''t work properly.
•
Replace the water pump, if it doesn''t work properly.
Immerse the thermostat in boiling water and inspect.
•
After removing the thermostat, check if it works properly.
※ Check the thermostat opens at the valve opening temperature.
•
Replace the thermostat, if it doesn''t work properly.

Thermostat Repair procedures
Removal     Removal of the thermostat may have an adverse effect, causing a reduction in cooling efficiency. Do not remove the thermostat, even if the engine tends to o ...

Cylinder Block
...

Other Information:

Description and Operation
Function Audio Bluetooth System General Features – This audio system supports Bluetooth® hands-free and stereo-headset features. – HANDS-FREE feature : Making or receiving ...

Front Disc Brake Components and Components Location
Components 1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer ...

Categories


Copyright © www.kisedona.com 2016-2024