Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the temperature control actuator connector. |
3. |
Verify that the temperature control actuator operates to the
cool position when 12V is connected to terminal 3 and ground to terminal
7.
Verify that the temperature control actuator operates to the warm position when connected in reverse.
|
4. |
Connect the temperature control actuator connector. |
5. |
Turn the ignition switch ON. |
6. |
Check the voltage between terminals 5 and 6.
Specification
It will feedback the current position of the actuator to controls. |
7. |
If the measured voltage is not within the specification,
substitute with a verified temperature control actuator and check for
proper operation. |
8. |
Replace the temperature control actuator if it is proved that there is a problem with it. |
Replacement |
[Driver''s side] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the driver''s side shower duct (A) after loosening the screw. |
4. |
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws. |
5. |
Install in the reverse order of removal. |
[Passenger''s side] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws. |
4. |
Install in the reverse order of removal. |
Opening the fuel filler lid
The fuel filler lid must be opened from inside the vehicle by pulling up the
fuel filler lid opener.
If the fuel filler lid does not open because ice has formed around it, tap lightly
or push o ...
Cowl Side Trim Components and Components Location
Component Location
1. Cowl side trim
...