Replacement |
Put on gloves to protect your hands. |
|
1. |
Using a screwdriver or remover, remove the tail gate upper trim (A). |
2. |
Install in the reverse order of removal.
|
Put on gloves to protect your hands. |
|
1. |
Remove the tail gate upper trim. |
2. |
After loosening the mounting screw, remove the tail gate side trim (A). |
3. |
Install in the reverse order of removal.
|
Put on gloves to protect your hands. |
|
1. |
Remove the tail gate upper trim. |
2. |
Remove the tail gate side trim. |
3. |
Remove the inside handle cap (A). |
4. |
Loosen the screw and remove the inside handle (B). |
5. |
After loosening the mounting slips and screws, remove the tail gate trim (A). |
6. |
Install in the reverse order of removal.
|
Compressor Description and Operation
Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low tempera ...
Rear Mode Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when 12V is connected t ...