Kia Sedona: Tail Gate Latch Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Latch Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the tail gate trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the tail gate latch connector (A).

3.	Disconnect the tail gate motor connector (B) after loosening the nuts.

4.	Loosen the torx driver and remove the tail gate latch assembly (A).

Install in the reverse order of removal.

•	Make sure that the tail gate locks/unlocks and opens/closes properly.

•	Adjust the tail gate alignment.

•	Make sure that the connectors are connected properly.

Tail Gate Latch Components and Components Location

Component Location 1. Tail gate latch assembly ...

Tail Gate Back Panel Components and Components Location

Component Location 1. Tail gate back panel ...

Other Information:

Good driving practices
Never move the gear shift lever from P (Park) to any other position with the accelerator pedal depressed. Never move the gear shift lever into P (Park) when the vehicle is in motion. Slow do ...

Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system. Therefore, if abnormal operation ...

Kia Sedona: Tail Gate Latch Repair procedures

Tail Gate Latch Components and Components Location

Tail Gate Back Panel Components and Components Location

Other Information:

Categories