Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the tail gate trim [LH].
(Refer to Body - "Tail Gate Trim") |
3. |
Disconnect the STG spindle connector (A). |
4. |
Using a screwdriver, loosen the bracket (B) mounting bolts after lifting the socket clips (A) up slightly. |
5. |
Remove the STG spindle assembly (C).
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim") |
3. |
Remove the tail gate trim [RH].
(Refer to Body - "Tail Gate Trim") |
4. |
Pull up the bottom of rear A/C duct (A). |
5. |
Remove the third row seat belt upper anchor (A) after loosening the bolt.
|
6. |
Loosen the mounting bolt (A). |
7. |
Remove the rear A/C duct (A) after loosening the bolt. |
8. |
Disconnect the STG spindle connector (A). |
9. |
Using a screwdriver, loosen the bracket (B) mounting bolts after lifting the socket clips (A) up slightly. |
10. |
Remove the STG spindle assembly (C).
|
Installation |
1. |
Install the STG spindle assembly.
|
2. |
Connect the STG spindle connector. |
3. |
Install the tail gate pillar trim [LH]. |
4. |
Connect the negative (-) battery terminal. |
1. |
Install the STG spindle assembly.
|
2. |
Connect the STG spindle connector. |
3. |
Install the rear A/C duct. |
4. |
Install the third row seat belt upper anchor.
|
5. |
Install the luggage side trim [RH]. |
6. |
Install the tail gate pillar trim [RH]. |
7. |
Connect the negative (-) battery terminal. |
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one to two minutes, and then stop it. If
the pedal depress ...
24,000 km (15,000 miles) or 12 months
❑ Rotate tire
❑ Inspect battery condition
❑ Inspect air cleaner filter
❑ Inspect vacuum hose
❑ Inspect air conditioning refrigerant
❑ Inspect brake hoses ...