Inspection |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the fuel pressure regulator valve connector. |
3. |
Measure resistance between the fuel pressure regulator valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
When removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, injury may be caused by leakage of
high pressure fuel. For this reason, do not attempt any repairing
immediately after engine stops.
|
1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") |
2. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
3. |
Remove the high pressure fuel fump form (A). |
4. |
Disconnect the fuel pressure control valve connector (A) and fuel feed tube quick-connector (B). |
5. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold") |
6. |
Remove the high pressure fuel pipe.
(Refer to Fuel Delivery System - "Fuel Line") |
7. |
Remove the mounting bolts (A), and then remove the high pressure fuel pump (B) from the cylinder head assembly
|
Installation |
|
|
|
1. |
Install in the reverse order of removal.
|
Heater & A/C Control Unit (Rear) Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...
Description and Operation
Description
It''s a system that uses illumination sensor to automatically
turn ON the tail lamp and head lamp based on the change in surrounding
environment''s illumination condition. It activa ...