Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the VIS valve connector. |
3. |
Measure resistance between the VIS valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
[Valve 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the variable intake solenoid valve connector (A). |
3. |
Disconnect the vacuum hoses (B) from the valve. |
4. |
Remove the mounting nut (C), and then remove the valve from surge tank. |
[Valve 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the variable intake solenoid valve connector (A). |
3. |
Disconnect the vacuum hoses (B) from the valve. |
4. |
Remove the mounting nut (C), and then remove the valve from surge tank. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Hands free switch Schematic Diagrams
Circuit Diagram
...
Engine Mounting Components and Components Location
Components
1.Engine mounting support bracket2.Engine mounting bracket3.Transaxle mounting bracket4.Roll rod bracket
...