Based on information from various sensors, the ECM can
calculate the fuel amount to be injected. The fuel injector is a
solenoid-operated valve and the fuel injection amount is controlled by
length of injection time. The ECM controls each injector by grounding
the control circuit. When the ECM energizes the injector by grounding
the control circuit, the circuit voltage should be low (theoretically
0V) and the fuel is injected. When the ECM de-energizes the injector by
opening control circuit, the fuel injector is closed and circuit voltage
should momentarily peak, and then settle at system voltage.
Rear Axle Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damag ...
Special Service Tools
Special Service Tools
Tool Name / NumberIllustrationDescriptionStrut spring compressor09546-26000Used for compressing coil springBall joint remover09568-4A000Used for removing ball joints (upper ...