Kia Optima Manuals

Kia Sedona: Accelerator Position Sensor (APS) Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sedona YP Service ManualKia Sedona: Accelerator Position Sensor (APS) Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator
Position
Output Voltage (V) [Ref=5V]
APS1
APS2
C.T
0.7 ~ 0.8
0.29 ~ 0.46
W.O.T
3.85 ~ 4.35
1.93 ~ 2.18

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and then remove the accelerator pedal module.

Installation
1.
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS) Specifications
Specification ItemSpecificationSupply Voltage (V)5Operation Voltage (V)4.75 ~ 5.25 Pressure [kPa (kgf/cm², psi)]Output Voltage (V) [Ref=5V]-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5 ...

Other Information:

TPMS Receiver Description and Operation
Description 1. Mode (1) Virgin State • The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. • In this state, there ...

Components and Components Location
Components 1. LDWS ON/OFF switch2. Instrument cluster3. LDWS unit ...

Categories


Copyright © www.kisedona.com 2016-2024