Inspection |
[Resistance Inspection] |
1. |
Turn the ignition switch OFF. |
2. |
Remove the OTS. (Refer to "Removal") |
3. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
[Voltage Inspection] |
1. |
Connect the GDS to DLC. |
2. |
Turn the ignition ON or idle. |
3. |
Check the OTS temperatuere in the GDS service data. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the connector (A), and then remove the CVVT oil temperature sensor (B). |
Installation |
|
1. |
Install in the reverse order of removal.
|
Transaxle ranges
The indicator in the instrument cluster displays the shift lever position when
the ignition switch is in the ON position.
P (Park)
Always come to a complete stop before shifting into P (Park). Thi ...
IMS (Integrated Memory System) module Components and Components Location
Components
Connector Pin Information
No.Connecter AConnecter BConnecter CConnecter D1-Batt (+)--2Front tilt motor (Up)GND-Seat rear height sensor3Rear height motor (Up)Batt (+)Slide switch signa ...