Inspection |
1. |
Connect the GDS to the Data Link Connector (DLC). |
2. |
Measure the output voltage of the RPS at idle and various engine speed.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). |
3. |
Remove the intake manifold.
(Refer to Engine Mechanical System - “Intake Manifold”) |
4. |
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Photo Sensor Description and Operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light r ...
Fuel Gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
✽ NOTICE
The fuel tank capacity is given in chapter 8.
The fuel gauge is supplemented by a low fuel warn ...