Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the HO2S connector. |
3. |
Measure resistance between the HO2S terminals 3 and 4. |
4. |
Check that the resistance is within the specification.
|
Removal |
Note that the SST (Part No : 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor. |
[Bank 1/Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 1/Sensor 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 2/Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (A). |
[Bank 2/Sensor 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the connector (A). |
3. |
Remove the heated oxygen sensor (B). |
Installation |
|
Note that the SST (Part No : 09392-1Y100 or 09392-2H100) is used when removing the heated oxygen sensor. |
1. |
Install in the reverse order of removal.
|
Tail Gate Assembly Repair procedures
Replacement
Wear gloves to protect hands from injury.
When removing and installing the tail gate, work in a group of two or more.
1. ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft (if equipped). The ignition
key can be removed only in the LOCK position.
ACC (Accessory)
The steering wheel is unlocked and electrical ac ...