Removal |
[Bank 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold") |
3. |
Remove the delivery pipe.
(Refer to Fuel Delivery System - "Delivery pipe") |
4. |
Remove the mounting bolt (A), and then remove the sensor from the cylinder block. |
[Bank 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold") |
3. |
Remove the delivery pipe.
(Refer to Fuel Delivery System - "Delivery pipe") |
4. |
Remove the mounting bolt (A), and then remove the sensor from the cylinder block. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with an L wrench (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
...
216,000 km (135,000 miles) or 108 months
❑ Rotate tire
❑ Inspect battery condition
❑ Inspect air cleaner filter
❑ Inspect vacuum hose
❑ Inspect air conditioning refrigerant
❑ Inspect brake hoses ...