Inspection |
1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
|
Removal |
|
[Bank 1/Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the camshaft position sensor connector (A). |
4. |
Remove the mounting bolt, and then remove the engine hanger (A). |
5. |
Remove the mounting bolt, and then vertically remove the sensor (A) from the cylinder head cover. |
[Bank 1/Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the camshaft position sensor connector (A). |
4. |
Remove the mounting bolt, and then vertically remove the sensor from the cylinder head cover. |
[Bank 2/Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the camshaft position sensor connector (A). |
3. |
Remove the mounting bolt, and then vertically remove the sensor (B) from the cylinder head cover. |
[Bank 2/Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the camshaft position sensor connector (A). |
3. |
Remove the mounting bolt, and then vertically remove the sensor (B) from the cylinder head cover. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Windows
(1) Driver ...
Rear Hub - Carrier Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to dama ...