Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ECTS connector. |
3. |
Remove the ECTS (Refer to "Removal"). |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner") |
3. |
Disconnect the engine coolant temperature sensor connector (A). |
4. |
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
|
Installation |
|
1. |
Install in the reverse order of removal. |
2. |
Supplement the engine coolant.
(Refer to Engine Mechanical System - "Coolant") |
Front Seat Shield Outer Cover Repair procedures
Replacement
[Front seat shield front cover]
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the re ...
To operate
Type B
Type C
Go to the User Settings Mode (Driving Assist) and select FCW (Forward Collision
Warning) on the LCD display (For more details, refer to "LCD Display" in chapter
4.).
...